吕敏, 冯志江, 杨笛, 张素娟. 熔锥型宽带耦合器的研制[J]. 应用光学, 2007, 28(6): 793-796.
引用本文: 吕敏, 冯志江, 杨笛, 张素娟. 熔锥型宽带耦合器的研制[J]. 应用光学, 2007, 28(6): 793-796.
Lü Min, FENG Zhi-jiang, YANG Di, ZHANG Su-juan. Development of fused biconical taper wide band coupler[J]. Journal of Applied Optics, 2007, 28(6): 793-796.
Citation: Lü Min, FENG Zhi-jiang, YANG Di, ZHANG Su-juan. Development of fused biconical taper wide band coupler[J]. Journal of Applied Optics, 2007, 28(6): 793-796.

熔锥型宽带耦合器的研制

Development of fused biconical taper wide band coupler

  • 摘要: 介绍了全光纤熔融拉锥型3dB宽带耦合器的理论设计,根据理论设计制作了样品。应用耦合模理论分析了全光纤非对称熔融拉锥型耦合器的宽带特性;提出了3dB宽带耦合器的制作方案,在此基础上制作了样品;对样品进行测试,样品带宽大约为300nm(在1300nm~1600nm波长之间),附加损耗小于0.5dB,完全达到了实用化的要求。

     

    Abstract: 3dB wide band coupler is a passive device widely used in optical fiber communication system, optical fiber sensor, optical fiber measurement technology and signal processing system. A fiber fused biconical taper (FBT) 3dB wide band coupler was designed and some samples were manufactured. The bandwidth characteristics of asymmetric FBT coupler were analyzed by coupledmode equation. The bandwidth of the wide band coupler is about 300nm (between 1300nm and 1600nm), while its excess loss is less than 0.5dB.

     

/

返回文章
返回